<3D Wax Carving>
Products
MAGIC-70
1. Engraver Starting Point Setting Before starting engraving, you should set the engraver starting point into the same location as the 3D model starting point. If the engraver starting point is not properly set, engraving may be made on the undesired location, and in some cases, tools, materials or vise may get damaged. |
|
.
2. Open 3D Model File
Click File → Start Wizard → DeskProto Wizard → Basic 3D Milling → Next → Load Geometry.
Click File → Start Wizard → DeskProto Wizard → Basic 3D Milling → Next → Load Geometry.
.
.
.
5. Create Tool Paths
Go to Create → Calculate Toolpaths. Red tool paths are created on 3D model in operation.
Go to Create → Calculate Toolpaths. Red tool paths are created on 3D model in operation.
.
6. Write NC Data File
You can save the tool paths created as NC data file.
Go to Create → Write NC-Program to save the file.
You can save the tool paths created as NC data file.
Go to Create → Write NC-Program to save the file.
.
7. NC-Spooler Run and Setting
NC-Spooler is the program that sends NC data file created in DeskProto to the engraver.
1. Run Magic Art Program and go to Tool → NC-Spooler to open NC-Spooler window.
2. In the initial NC-Spooler run, communication port between the engraver and the program should be configured.
For communication configuration, go to Tool → Communication Port Configuration and select Baud 115200 and XON/XOFF as shown in the below figure.
NC-Spooler is the program that sends NC data file created in DeskProto to the engraver.
1. Run Magic Art Program and go to Tool → NC-Spooler to open NC-Spooler window.
2. In the initial NC-Spooler run, communication port between the engraver and the program should be configured.
For communication configuration, go to Tool → Communication Port Configuration and select Baud 115200 and XON/XOFF as shown in the below figure.
.
8. NC Data Transfer
※ You must set the engraver starting point before sending NC data.
1. Go to File → Add NC data files to open the NC data file saved in DeskProto.
2. Select the file to be open in File Name and click Transmit Selected to send NC data to the engraver.
※ You must set the engraver starting point before sending NC data.
1. Go to File → Add NC data files to open the NC data file saved in DeskProto.
2. Select the file to be open in File Name and click Transmit Selected to send NC data to the engraver.
3) Engrave
4) Completed
4) Completed